GE Appliances
WSM2420/80D – GE® 24” Unitized Spacemaker® Washer/Dryer
Dimensions (in inches)
Electrical Requirements:
21-5/16
8
WSM2420D:
Electric Dryer –This appliance should be connected to an individual, properly
grounded branch circuit with 120/240V single-phase 60Hz electrical service and should
be protected by 30-amp time-delay fuses or circuit breakers. This appliance is
manufactured with the neutral connected to the frame. Power cord should be
purchased separately.
27-5/8
27-5/8
71-3/4
Distance
from vent
to back 4-1/2"
Note: These appliances are not approved for 120-volt operation.
71-3/4
1-1/2
WSM2480D:
Gas Dryer – This appliance should be connected to an individual, properly grounded
branch circuit with a three-prong grounding-type receptacle and 120-volt single-phase
60 Hz electrical service and should be protected by 15- or20-amp time-delay fuses or
circuit breakers. This appliance is equipped with a 6-foot long flexible U.L. listed
20-amp power cord to match a 15-amp receptacle.
38
32-1/8
27-1/2
Drain
28-5/8
Water
inlet-
cold
32-1/2
Gas Rated input 10,500 BTU/HR. Factory equipped for natural gas. Tested for LP gas.
Floor line
27-1/4
23-7/8
27-1/4
Dryers must be exhausted to the outside.
1" For leveling legs
23-7/8
Installation Information:
For complete information, see installation instructions packed with the product.
Power Cord Location
Power
Cord Hole
9-1/2
41-1/2
For answers to your Monogram, GE Profile™ or
®
GE® appliance questions, visit our website at
Specification Revised 5/09
360327
Listed by
Underwriters
Laboratories
Back View
GEAppliances.com or call
GE Answer Center® service, 800.626.2000.
GE Appliances
WSM2420/80D – GE® 24” Unitized Spacemaker® Washer/Dryer
Features and Benefits
• Two Wash/Spin speeds – Matches wash action to fabric type for better cleaning and clothes
care
• Three Wash Cycles – A cycle for almost every fabric, from permanent press to delicates
• Three Wash/Rinse Temperatures – Allow you to select the right temperature for better wash
results and long fabric life
• Three Water Levels – Minimize water waste, allowing you to select water level based on
load size
• Electromechanical Controls – Selector knob turns smoothly in either direction, simplifying
cycle selection
• Model WSM2420DWW – White on white (Electric)
• Model WSM2420DCC – Bisque on bisque (Electric)
• Model WSM2480DWW – White on white (Gas)
Specification Revised 5/09
360327
|