58-0578-01.fm Page 1 Tuesday, August 21, 2001 2:52 PM
F u j i t s u P C C o r p o r a t i o n
Screen Protector
Installation Guide
FMWSP11 / FPCSP01
I N S T R U C T I O N S
This screen protector is designed for use on the Stylistic LT
C-500 and Stylistic LT P-600 pen tablet display screens.
Notes
•
Before installing a new screen protector, remove any
screen protector that is already installed. Check to see
which corner of the screen protector is not glued to the
surface of the display; ordinarily, it will be the bottom
left corner. A notch in the corner allows you to slide a
firm, pliable implement (such as a credit card) under
the screen protector for removal. Do not use a metal
implement; it could scratch the screen.
•
To ensure good adhesion, clean the screen with a soft
cotton cloth dampened with isopropyl alcohol before
installing the screen protector. When the alcohol dries,
it may leave streaks on the screen. If streaking occurs,
buff the screen gently with a clean, dry cloth.
58-0578-01.fm Page 3 Tuesday, August 21, 2001 2:52 PM
4. Remove the protective film from the top of the screen
protector, as shown in Figure 3.
5. Wipe the exposed surface of the screen protector with a
clean dry cloth to remove any adhesive left behind by the
protective film.
Figure 2. Installing the Screen Protector
Figure 3. Removing the Protective Film
3
58-0578-01.fm Page 4 Tuesday, August 21, 2001 2:52 PM
5200 Patrick Henry Drive
Santa Clara, CA 95054
For more information, visit our Web site
For technical support call:
1-800-8Fujitsu (1-800-838-5487)
Fujitsu and the Fujitsu logo are registered trademarks of Fujitsu, Ltd. Stylistic is a
trademark of Fujitsu PC Corporation. All other trademarks mentioned herein are the
property of their respective owners. We cannot guarantee the accuracy of the contents of
this document. We disclaim liability for errors, omissions or future changes.
© 2001 Fujitsu PC Corporation. All rights reserved.
FPC58-0578-01
B5FY-1621-01EN-00
4
|