INSTALLATION MANUAL
DUCTLESS KIT
FDK-021
< NAME OF PARTS >
The liner and the power unit are
completely installed.
Please refer to each installation
book for the installation method.
CONVERSION DUCT
6" TO 3-1/4" x 10"
GRILL
Assemble the duct and the
conversion duct temporarily, and
decide the location of the grill.
Adjust length by cutting the duct
to preferred length.
Cut a rectangular hole for the
grill in the soffit when the
location of the grill is decided.
Remove the protection seal of
the grill.
CABINET
POWER UNIT
LINER
DUCT
6" x 2'
CHARCOAL FILTER (2)
SCREWS (2)
Please confirm contents in the above figure first.
FIG 1
FIG 2
CONVERSION DUCT
6" TO 3-1/4" x 10"
Attach the conversion duct to
the wall or soffit.
SOFFIT
STRAIGHT
CONVERSION
DUCT
SOFFIT
GRILL
Attach the grill with the
screws provided to the soffit.
Please refer to cross section
FIG4 for detailed assembly.
Do the taping to each joint
with duct tape.
DUCT TAPE
(NOT INCLUDED)
(NOT INCLUDED)
GRILL
When installing without a
soffit, please refer FIG5
BRACKET
(NOT INCLUDED)
DUCT TAPE
(NOT INCLUDED)
CAUTION
Do not use screws to join the duct parts.
Be careful not to expand the hole too much, and be
careful not to damage soffit etc.
6" DUCT
< The cross section>
FIG 4
FIG 3
FIG 5
BACKSIDE
FLANGE
The charcoal filter is placed
on the backside of the slot
filter and it is reinstalled in
the unit.
Finally, please install wood
hood.
Note do not place the
charcoal filter over screw
hole.
Your installation is now
complete. If you should require
service or replacement parts on
your ventilation system. contact:
SCREW
ALUMINUM SLOT FILTER
CHARCOAL
FILTER
Fuji Industrial USA,Inc.
16300 Christensen Rd, #212 Seattle, WA 98188
1-888-547-9880
NOTE
The charcoal filter should be replaced every three to
six months, depending on the amount of cooking that
is done.
FIG 6
FIG 7
READ AND SAVE THESE INSTRUCTIONS.
Keep this manual in a convenient place for future reference.
FUJI INDUSTRIAL CO.,LTD .
032582
|