™
Kick‘n Crawl Barn
Instructions
Model Number 71699
Play Quilt
Barn
Product features may vary from the photos above.
• For Ages 0 and Up
• Please save these instructions for future reference.
• Activity toy requires two replaceable button-cell (LR44 or equivalent) alkaline batteries. Dispose of batteries safely.
• Adult assembly is required for battery replacement.
• Tool required for battery replacement: Phillips screwdriver (not included).
Assembling the Barn
Battery Replacement
Activity Toy Straps
CAUTION
This product contains small parts.
Batteries must be replaced by an adult.
Plastic Tab
Activity Toys
Battery Compartment
Battery Compartment Door
Fastener
Straps
Slots
Sleeve
Plastic Tab
Activity
Toys
Fastener Straps
Tube
2 x LR44 or Equivalent
Support
Shown Actual Size
• Slide the tubes through the sleeves in each side of the
play quilt.
• Position the supports so that the sides with the slots
face inward.
• Fit the two small fastener straps on each end of the
tubes through the slots inside the circular openings in
the supports. Fasten the fastener straps together to
secure the tubes to the supports.
• Locate the battery compartment door on the back of the
chicken activity toy.
• Loosen the screw in the battery compartment door with a
Phillips screwdriver. (The screw will remain in the door.)
• Lift the battery compartment door to open.
• Fit the plastic tabs at the corners of the play quilt into
the slots in the supports.
• Fasten the activity toys to the activity toy straps.
• Remove the used batteries and dispose of them properly.
• Insert two new button-cell (LR44 or equivalent) alkaline
batteries in the battery compartment as shown. Make sure
the flat side of each battery (printed with the battery desig-
nation) faces up.
Helpful Hint: We recommend using alkaline batteries for
longer battery life.
Carry-Along
• Replace the battery compartment door and tighten the
screw with a Phillips screwdriver. Do not over-tighten.
Fastener Strap
• When lights or sounds from this toy become faint or stop
working, it’s time to replace the batteries!
Battery Tips
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Remove the batteries during long periods of non-use.
Always remove exhausted batteries from the toy. Battery
leakage and corrosion can damage this toy. Dispose of
batteries safely.
• Never short circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type as recom-
mended in the "Battery Replacement" instructions are to
be used.
• Place the play quilt print side up on a flat surface.
• Attach the activity toys to the straps on the sides of the
play quilt and place the toys on top of the quilt.
• Locate the fastener strap at one end of the play quilt. Place
the supports and tubes at the opposite end of the play quilt
and roll the play quilt from end to end.
• Fit the fastener strap through the loop on the outside of the
play quilt and fasten to close.
3
Battery Tips
FCC Note (United States Only)
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• If removable rechargeable batteries are used, they are
only to be charged under adult supervision.
• Rechargeable batteries are to be removed from the toy
before they are charged.
• If you use a battery charger, it should be examined
regularly for damage to the cord, plug, enclosure and
other parts. Do not use a damaged battery charger until
it has been properly repaired.
• When sounds from this toy become faint or stop working,
it’s time for an adult to replace the batteries!
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
Care
• Consult the dealer or an experienced radio/TV technician
for help.
• Machine-wash the play quilt in cold water on the gentle
cycle. DO NOT use bleach. Tumble dry on low heat.
• Surface wash the tubes, activity toys and supports with a
mild cleaning solution.
• This toy has no consumer serviceable parts. Please do not
take this toy apart.
Consumer Information
Questions? We'd like to hear from you!
Call Fisher-Price Consumer Relations, toll-free at
1-800-432-KIDS, 8 AM - 6 PM EST Monday through Friday.
Hearing-impaired consumers using TTY/TTD equipment, please
call 1-800-382-7470. Or, write to: Fisher-Price Consumer Relations,
636 Girard Avenue, East Aurora, New York 14052.
If you have any questions about this product:
In CANADA, Mattel Canada Inc. 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2. Questions? 1-800-567-7724
In GREAT BRITAIN, Mattel U.K., Ltd. Helpline: 01628 500303.
In AUSTRALIA, Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1-800-800-812 (valid only in Australia).
Fisher-Price, Inc., is a subsidiary of Mattel, Inc.,
East Aurora, New York 14052, U.S.A.
©2000 Mattel, Inc. All Rights Reserved.
® and ™ designate U.S. trademarks of Mattel, Inc.
Printed in China
71699pr-0920
|