Business Wire Binder
Please read these instructions before use.
Veuillez lire ces instructions avant utilisation.
Lea estas instrucciones antes del uso.
fellowes.com
SET UP
1
2
3
4
1. Ensure the machine is on a
stable surface.
2. Check waste tray is empty
and correctly fitted.
3. Lift the lid. Ensure the wire
closing lever is pushed backwards.
4. Lift the punch handle to its
upright position.
BEFORE YOU BIND
1
2
3
1. Select the correct wire comb
diameter using the comb
storage tray.
2. Hang the selected wire
comb onto wire comb support.
3. Test punch scrap sheets to
check edge guide setting.
STEPS TO BIND
1
2
3
4
Max 15
(80gsm)
1. Punch sheets in small
batches that do not overload
the machine or user.
2. Starting with the rear cover.
Load punched sheets directly onto
the hanging open wire comb.
3. Punch and hang the front
cover. Punch and hang the
remaining sheets.
4. Lift the wire comb upwards off the
hooks. Carefully place into the open
wire closing mechanism. Ensure the
wire comb is open and touching the
bottom of the mechanism.
6
7
8
5
5. Lift the wire closing lever
6. Check the closed seam. If
the seam is not closed correctly,
the document can be placed
into the jaws and closed again.
7. To hide the seam, turn the
rear cover backwards. The front
cover is now visible. The seam is
hidden inside the document.
8. Check wire seam closure is
complete. Loose binding allows
sheet loss. Good closure retains
all sheets.
forwards. The closing scale guide is
on the moving jaw. Close the jaws
until the wire gauge shows the size
of wire being closed.
3
REMOVAL OF WASTE CLIPPINGS
CORRECTING A BOUND DOCUMENT
Wire binding is a secure binding system. Additional sheets cannot be
added unless the document is disassembled and then re-bound.
The waste tray is located under the machine and is accessed from the
right side. For best results empty the tray regularly.
STORAGE
Lower the punch handle to the horizontal position. Lower the lid.
TROUBLESHOOTING
Problem
Cause
Solution
Punched holes are not central
Machine will not punch
Punch holes are not parallel to edge
Edge guide not set
Blockage
Adjust edge guide until hole pattern is correct
Check waste tray in empty. Check for blockage to paper entry
Debris is stuck below dies
Take stiff cardboard and slide into the paper entry. Move the
cardboard sideways to release any stray clippings into the
waste tray
Partial holes
Sheets not correctly aligned to punch pattern
Possibly overloading the machine
Adjust edge guide and test punch scrap sheets until correct
Damaged hole edges
Punch plastic covers with paper sheets. Reduce number of
sheets being punched
Waste tray leaks
Waste tray is not correctly inserted or ‘burst
feature’ has activated
Check waste tray is empty and ‘burst feature’ is closed
Sheets fall out of document
Wire comb is not closed enough
Check closure of wire comb. Place into closing mechanism and
improve binding closure.
WARRANTY
Fellowes warrants all parts of the binder to be free of defects in material and workmanship
for 2 years from the date of purchase by the original consumer. If any part is found to be
warranty period set forth above. In no event shall Fellowes be liable for any consequential
damages attributable to this product. This warranty gives you specific legal rights. You may
defective during warranty period, your sale and exclusive remedy will be repair or replacement, have other legal rights that vary from this warranty. The duration, terms and conditions of this
at Fellowes’ option and expense, of the defective part. This warranty does not apply in
cases of abuse, mishandling or unauthorised repair. Any implied warranty, including that of
warranty are valid worldwide, except where different limitations, restrictions or conditions may
be required by local law. For more details or to obtain services under this warranty, please
merchantability or fitness for particular purpose, is hereby limited in duration to the appropriate contact Fellowes or your dealer.
4
Useful Phone Numbers
Help Line
Europe
00-800-1810-1810
+1-800-234-1185
+1-800-955-0959
Australia
+1-800-33-11-77
Mexico
Canada
+1-800-665-4339
United States
Fellowes
Australia
Benelux
Canada
+61-3-8336-9700
+31-(0)-76-523-2090
+1-905-475-6320
Japan
+81-(0)-3-5496-2401
+82-2-3462-2844
Korea
Malaysia
Polska
+60-(0)-35122-1231
+48-(0)-22-771-47-40
+65-6221-3811
Deutschland
España
+49-(0)-5131-49770
+34-91-748-05-01
+33-(0)-1-30-06-86-80
+39-071-730041
Singapore
United Kingdom
United States
France
+44-(0)-1302-836836
+1-630-893-1600
Italia
&,-.ꢀCdglddYꢀ6kZcjZ!ꢀ>iVhXV!ꢀ>aa^cd^hꢀ+%&)("&%.*ꢀꢀ™ꢀꢀJH6ꢀꢀ™ꢀ+(%"-.("&+%%ꢀ
fellowes.com
Australia
Benelux
Canada
China
Deutschland
España
France
Italia
Japan
Korea
Polska
Singapore
United Kingdom
United States
2006 Fellowes, Inc. Part No. 403054
|