Ericsson RX8310
Distribution Receiver
The Ericsson RX8310 Distribution Receiver lets operators take full advantage of the efficiency
improvements from DVB-S2 modulation, PREKOR™ Dynamic Pre-correction System by Ericsson,
and MPEG-4 AVC compression to distribute three times the amount of content through a satellite
transponder verses traditional satellite distribution solutions.
The RX8310 combines a DVB-S2 capable demodulator with Director by Ericsson secure content
delivery and over-air receiver control solution as a standard feature. For high capacity digital
turn-around, the RX8310 provides the option to decrypt multiple services allowing decryption of a
complete multiplex of channels with a single unit. Single service decoding options for MPEG-2 and
MPEG-4 AVC 4:2:0 SD video, and HD service down-conversion means the RX8310 can provide a
simple and cost-effective route to hand-off video into an analog network or for service monitoring.
The RX8310 simplifies content acquisition for cable, satellite and telco operators in the all-digital
future of TV broadcasting.
PRODUCT OVERVIEW
BASE UNIT FEATURES
The Perfect Choice for a Large Network
RX8310 – Distribution Receiver
(RX8310/BAS, FAZ 101 0108/18)
The RX8310 is the perfect receive device for distribution of video
services throughout a large network. The RX8310 provides the
most up-to-date feature-set, combining maximum transmission
efficiency with easy remote management of the receiver
population. The RX8310 provides all major functionality and
connectivity required to hand-off the service into the remote
network.
The following features are available as standard:
• Four input DVB-S QPSK satellite demodulator
• Transport stream input with ASI connection
• Transport stream output with ASI connection
• Director single service decryption
• Front panel and Web browser control, with alarm relay
Increased Distribution Capacity and Efficiency
• SCTE 35 controlled contact closures for ad-insertion
The RX8310 distribution receiver, in combination with Ericsson’s
MPEG-4 AVC encoders and PREKOR dynamic pre-correction,
leads to a highly efficient video distribution system. Combined
with the addition 30 percent increase in channel capacity of
DVB-S2 the RX8310 allows operators to achieve three times the
amount of content through a transponder.
signaling
Optional features include:
• DVB-S2 QPSK and 8PSK demodulation
• Transport stream over IP output
• Director multi-service decryption
Simplified Control and Lower Cost of Operations
• MPEG-2 SD 4:2:0 video decoding through CVBS output
• MPEG-2 HD 4:2:0 down-conversion through CVBS output
• MPEG-4 AVC SD video decoding through CVBS output
• MPEG-4 AVC HD down-conversion through CVBS output
Organizations with large populations of RX8310 receivers and
other Ericsson receivers can simplify control by integrating with
the Director by Ericsson control system. Director provides remote,
over-air, single-view control from a central location, reducing the
need for on-site local operators.
• Two service Dolby® Digital audio decoding with 5.1 to 2.0
down-mixing
• AAC audio decoding with 5.1 to 2.0 down-mixing
• MPE IP data de-encapsulation
• Single service filtering and PID remapping
• Multi-service filtering and stream splitting
08-2011-v4
Ericsson RX8310 Distribution Receiver
SAMPLE CONFIGURATION
SPECIFICATIONS
Video and Audio Options
Input Interfaces
Conditional Access
MPEG-2 SD Decode
Transport Stream Input
Format: DVB ASI
Director by Ericsson
Profiles: MP@ML
Single service Director decryption
Multi-service Director decryptiony - up to 24 services
Stream Processing
Max video rate: 15 Mbps (MP@ML)
Video format: 480i and 576i 29.97, 25 fps
MPEG-2 HD with Down-conversion
Profiles: MP@HL
Connector: 1x BNC 75 Ohm
Max input rate: 160 Mbps
Packet length: 188/204 byte packets
Standard: EN50083-9
Single Service filtering
Filter multiple services to one outgoing servicey
Remap PIDs for the filtered service
Output: CBR on ASI and IPy SPTS
Multi-service filtering
Filter N incoming services to M outgoing servicesy
Number of services: 24 max. as 1xMPTS
Re-map PIDs on a single service
Output: CBR on ASI and IPy MPTS
Stream splitting - up to 8 services as IP SPTS
Control
Max. video rate: 80 Mbps (MP@HL)
Satellite Input
Video format: 1080i at 29.97 and 25 fps 720p at 59.94
and 50 fps
Connector: 4x F-Type, 75 Ohm
Modulation: DVB-S QPSK, DVB-S2 QPSKy, 8PSKy,
High definition video down-converted and presented as
SD only
16APSK*y
Frequency range: 950 MHz to 2150 MHz
Input Level: -25 dBm to -65 dBm
Symbol Rate: 1 Msym/s to 45 Msym/s (DVB-S) 1y(5) -
31(60*)Msym/s (DVB-S2)
SD video format: 480i @ 29.97 or 576i @ 25, 50 fps
MPEG-4 AVC SD Decode
Profiles: MP@L3
Max. video rate: 12 Mbps
Bit-rate: 81 (155*) Mbps max. (DVB-S2)
FEC, DVB-S: 1/2, 2/3, 3/4, 5/6, 7/8
Video format: 480i and 576i 29.97, 25 fps
MPEG-4 AVC HD with Down-conversion
Profiles: MP@L4, HP@L4
FEC, DVB-S2 QPSK: (1/4, 1/3, 2/5*), 1/2, 3/5, 2/3, 3/4,
4/5, 5/6, 8/9, 9/10
Front panel keypad and LCD
Director by Ericsson remote control
Ethernet
FEC, DVB-S2 8PSK: 3/5, 2/3, 3/4, 5/6, 8/9, 9/10
FEC, DVB-S2 16APSK: 2/3, 3/4, 4/5, 5/6, 8/9, 9/10
DVB-S2 FEC Frame: Short Frames*, Normal Frames
LNB Power: 13V, 18V or off, 22 kHz on/off
Standard: EN300 421, EN302 307
Max. video rate: 20 Mbps
Video format: 1080i @ 29.97 and 25 fps 720p @ 59.94
and 50 fps
Dual RJ45 10/100baseT control interface
Full SNMP control, Web browser interface
Physical and Power
High definition video down-converted and presented as
SD only
SD video format: 480i @ 29.97 fps or 576i @ 25, 50 fps
Video Processing
Outputs
Dimensions (W x D x H)
440 x 400 x 44mm (17.2 x 15.75 x 1.75“ approx.)
Input Voltage
DVB ASI-C
Down-conversion (HD to SD)
Connector: 2x BNC 75 ohms
ASI standard: EN50083-9
CVBS
Aspect ratio conversion (16:9 to 4:3): none, center cut
out, letter box, anamorphic - manual/AFD controlled
110 VAC / 240 VAC
VBI
Power Consumption
Closed captions, DVB Subtitle burn-in
45W max. (depending on options fitted)
Cooling
Connector: 2x BNC 75 ohms
Format: NTSC, PAL
WST, Inverted Teletext, EBU Teletext subtitles and non
subtitles, WSS, VITC, VITC in PES, VPS,
Integrated fans
Audio
VITS, NABTS, AMOL 48, AMOL 96, TV Guide
Audio Decoding
Environmental Conditions
Connector: 2x 9-pin D-type
Analog audio: two balanced stereo pairs
Decoded audio gain adjustment
Output Options
Operating Temperature
0°C to 50°C (32° to 122°F)
Storage Temperature
-20°C to 70°C (4° to 140°F)
Relative Humidity
MPEG-1 Layer-II audio
Dolby® Digital 2.0 decoding
Dolby Digital 5.1 down-mix to 2.0
AAC 2.0 decodingy
AAC 5.1 down-mix to 2.0y
Sampling rate: 48 kHz
No. stereo pairs: two
Transport Stream Output
Transport encapsulation into IP
MPTS/IP/UDP
5% to 95% (Non-condensing)
Compliance
SPTS/IP/UDP with single service filtering - CBR mode
2x GigE outputs, 100/1000 auto-sensing
High Speed Data Output
Features
CE marked in accordance with EU Low Voltage and
EMC Directives
Program selection for ATSC, DVB and MPEG-only
streams
MPE based data de-encapsulationy
EMC Compliance
EN55022, EN61000-3-210, EN61000-3-310, EN55024,
CISPR22, FCC CFR47 Part 15B Class A
Max. bit rate: 100 Mbps
Input transport rate up to 160 Mbps (Nominal)
One alarm relay, two relays under SCTE 35 control
Service cycling through all decodable services
Safety Compliance
*Check availability
y Indicates an option
EN60950-1, IEC60950-1, UL60950-1
EMEA
Australasia
Ericsson Television Pty Limited
Americas
Ericsson Television Inc.
Asia Pacific
Ericsson Television Limited
Ericsson Television Limited
Tel: +44 (0)23 8048 4000
Email: [email protected]
Tel: +61 2 9111 4999
Email: [email protected]
Tel: +1 (678) 812 6300
Email: [email protected]
Tel: +852 2590 2388
Email: [email protected]
© Ericsson AB. All rights reserved.
Ericsson maintains a policy of product improvement and reserves the right to modify the specifications without prior notice.
08-2011-v4
|