R
Mini Washing Machine
User's manual
Model: EW-2001MS
Please read this manual carefully before using.
Retain it for future reference.
Names of the parts
Timer knob
Control panel
Filter cap
Water inlet
Lint filter(Installed by user)
Panel support
Top lid
Pulsator
Cabinet
Drain hose
Base
Fixing leg
(four pieces)
Meaning and description of the symbols
Contents marked with that symbol are related
to the safety of the product and the personal
safety of the users. Please operate in strict
conformity to the contents, otherwise it may
cause damage of the machine or injure the
personal safety of the user.
Warning sign
Contents marked with that symbol are actions
forbidden to perform. Performing of those
actions may result in damage of the machine
or injure the personal safety of the user.
Forbidding sign
Please check if the power receptacle has good earthing
condition before using to guarantee your safety.
1
Safety precautions
Please insert the power cord into
special receptacle with rated vol-
tage.Be sure to use single-phase
three pins receptacle.The earthing
terminal of the receptacle must be
earthed reliably.If possible,please
adopt electric leakage protector.
When the machine is normally
using, please put the power plug
at the location easily to be insert-
ed and extracted by hand. Be sure
to pull the plug off when there's
power failure, or the machine is
being moved, cleaned or when it
is idle.
If the power cord is bad, to avoid risk it is required to replace it by the
technicians of our special shop or the after-sale service department.
Keep the pin of the power plug clean.
Do not put the machine at damp
place like the bathroom . Never
wash it with water. Do not place
wet laundries on the control panel.
Do not use water hotter than 50 C .
In case the washing machine is installed
on ground with carpet , do not block the
ventilation hole with carpet.
Do not wash water-proof laundries like
the raincoat, bike covers etc. to avoid
abnormal vibrations in spinning.
Ventilation hole at
the bottom of the
washing machine
Do not let the machine share one receptacle
with other electric appliances. If the power
plug is damaged, or the plugging into the
receptacle is loose, do not use the plug any
more.
Safety precautions
Do not stretch hands into the working
machine. It is dangerous even if the
rotation is slow. Take special care of
the children.
Do not decompose, repair or alter the
machine by yourself.
Do not put any hot or heavy items
( such as the kettle with hot water )
on the washing machine.
Do not wash laundries with volatile
materials (such as thinner, petrol etc.).
l
ro
et
er
P
inn
Th
Keep the machine away from direct
sunlight and heat source like the
heater.
Handicapped or children without care
shall not use the machine.
To protect your laundries and wash-
ing machine, please take out all of the
coins, buttons, sand, hairpin and
other foreign materials before washing.
Please check if the water faucet is open,
and if the connection of the water inlet
pipe is proper.
It is suggested to use foamless washing
powder.
Installation and adjustment
Please install and adjust the machine according to the requirement of the manual.
It is very important to your security and correct operating the machine.
Usage of the drain hose
When washing, the drain hose must be hung up, if you want to drain,
please refer to the below mention.
The drainage shall be smooth with the drain hose.
1.The height of the drain hose shall be
less than 10cm , or the drainage will
not be smooth enough and cause
<10cm
incomplete drainage.
2.Do not step on or press the drain hose.
3.If extra drain hose is needed , the inner
diameter of the extra hose shall not less
than 26mm, and the length shall not exceed
>
26mm
1.5m.
<1.5m
Install the lint filter
After opening the package, please take out the lint filter
from the document bag, install it to the filter cap of the
cabinet. See to the figure
Filter cap
Lint filter
4
Adjust the installation position
The largest permitted slope of the bearing surface of the washing machine is 2.
Slanting or uneven ground will cause unstable operation of the machine. Please
check with following methods:
Hang a becket with weight to confirm if the washing machine is horizontal.
Install the water inlet hose ; Select the water level
Insert the water inlet hose into the water
inlet jointer on the control panel.
(To dismantle the water inlet hose, you only
need to pull the hose out.)
water inlet hose
Water inlet entrance
Fill the water to the water level selected
according to the quantity of the laundries.
Attention:
Put in the laundries first before
water inlet.
Do not exceed the "Max " water
level otherwise the water may
overflow out of the machine.
water level
indicator
If the water level exceed the "Max "
water level ,in order to protect the
electrical component, the water flow
over to the base from overflow pipe,
flow out the washing machine.
5
Preparation before washing
Preparation before washing
1.Connect the water inlet hose.
2.Confirm that the washing machine is earthed
reliably . Then insert the power plug into the
receptacle. Do not connect the earth terminal
to the gas pipe and tap water pipe.
3.Hang the drain hose up.
Pay attention to followings before washing the laundries
Check if
The quantity of
When the pulsator
Clear the
Tie the long
strips; fasten
the buttons;
close zippers.
the laundries
has special
requirement
on washing
the laundries is running , the
shall not be too buttons of the
large. Stretch laundries may
and loosen the cause noise. For
laundries before the sake of
pocket. Take
out the coins,
sand, hairpins
etc.
putting them in discretion, please
the tub.
put the laundries
with buttons into
other laundries.
a. Check if the laundries are applicable for washing with machine.
b. Divide the laundries that are not colorfast from other laundries.
c. Put those laundries difficult to absorb water into water with hand.
d. For those laundries with heavy soil, please first remove the dirt like
mud or dust. For the parts with heavy soil, please apply detergent on
them in advance, which can make it easier to remove the soil.
e. For those laundries that may get lint ball and those with long fur, turn
it over before putting in.
f. Do not put those laundries polluted by chemicals into the washing
machine directly.
6
The musts in washing
The capacity of washing of the machinerefer to the
largest weight of the standard laundries under dry
condition that can be washed in one time. Laundries
quantity in one washing cycle shall be lower than
the rated capacity.
The thickness ,size , type of the cloth will influence the
actual washing capacity. It is suitable to put in reasonable
amount of laundries and the laundries can be turnedround
in washing for one time washing.
Usage of the detergent
How to use the whitener
Fill water to decided level. Dilute the whitener with container. Pour it slowly into the
washing tub.
Avoid using whitener on laundries with color or pattern as they are prone to lose color.
The whitener shall not touch the laundries directly.
Refer to the user's manual for the usage and quantity of the whitener.
For powder whitener, please dissolve it before using.
How to use the washing powder
Direct dissolved in the machine:
The powder is more prone to pollute the
1.Fill small quantity of water.
laundries than the detergent. Therefore
2.Add the powder . Run for 30 seconds to
please use it with proper quantity.
dissolve it completely.
It is suggested not to use high sudsing
detergent.
3.Put it in the laundries. Select suitable
water level.
The instant dissolving of the washing powder:
1.Prepare warm water of 30 C and a container.
2.Add the powder while stirring to fully
dissolve it.
Dosage of different washing powder is
different. Please refer to the instruction
of the washing powder for the detail
dosage.
Select the wash time
Wash timer
OFF
Please select wash time according to the laundries.
Laundries
Wash time minutes
About2~4
Silk(thin laundries)
Knitwear/chemical fiber
About3~6
About7~13
(To set to below 2 minute,
first set to 6 minute then
turn it back. it can increase
the service life of the timer).
About8~10
Cotton,blending,linen
About10~15
Very dirty and thick laundries
Finish washing
The pulsator stops rotating. Put down the drain hose
to discharge the water.
7
Disposal after washing
After using, please clean the lint and foreign materials of the lint filter and lint frame in time.
Otherwise it may influence your using the machine.
Please first pull off the power plug from the receptacle before cleaning.
Cleaning the lint filter
The lint filter must be used during washing.
It must be cleaned in time after each using.
1. Take off the lint filter
Put hand at the indicated position.
Push down to take it off. (See to
Figure 1)
Figure 1
2. Clean the lint
Put it in water and clean while it is still
wet.(See to Figure 2)
3. Install the lint filter
After cleaning, insert the bottom of
the lint filter (marked with "down side")
Figure 2
into the filter frame, then push the
upper part of the filter in (marked with
"up side"). (See to Figure 3)
Figure 3
Attention: be sure not to confuse the direction.
After washing, dismount the water inlet hose.
Pull off the power plug and hang up the
power cord.
Do not store water in the tub for long period.
Discharge the water immediately after each
using.
Wipe the complete unit with soft cloth
twisted dry.
Wipe with neutral detergent if too dirty.
Do not wash it directly by water.
Wipe off the water drops on the surface and
inside the tub with clean soft cloth. Open the
cover of the wash tub for some time (about
one hour), then close it.
Thinner
Petrol
Alcohol
Hang up the drain hose.
Trouble-shooting
The following phenomena are not breakdowns sometimes. Please confirm again before
sending it to repair.
Phenomena
How to check
The washing machine
does not act
Is there power failure?
Is the power plug inserted tightly?
Is the machine slanting?
Is there metal item inside the tub?
There's abnormal sound
inside the machine.
8
Packing list
Quantity
One piece
Name
User's manual
Warranty card
One piece
One piece
Filtrate cover
One piece
One piece
Water tub
Water inlet hose
Lint filter
One piece
One set
Mini Washing Machine
Specification
Water level/Water quantity (about)
1/7L 2/12L 3/18L
0.02 0.2
Injection pressure(MPa)
Rated washing capacity(kg)
2.0
|