WPC 210 A EU and MK • Installation Guide
The Extron® WPC 210 A EU and MK are wall mounted plates that accept HDMI video and
audio signals through one HDMI pigtail connector, and one 3.5 mm to captive screw connector.
The audio signal passes through the unit without modification and is output from the back via
captive screw connectors. The captive screw connectors accept 18 AWG (1.02 mm) to 26 AWG
(0.404 mm) wires.
•
•
The WPC 210 A EU mounts onto one-gang European junction boxes.
The WPC 210 A MK mounts onto MK electric type one-gang UK junction boxes.
AUDIO
AUDIO
HDMI
HDMI
WPC 210 A EU
WPC 210 A MK
WPC 210 A EU (FRONT)
SIDE
WPC 210 A MK (FRONT)
Preparing the Mounting Surface
Before starting the installation, do the following:
CAUTION: Risk of personal injury. Failure to check the items listed below may result
in personal injury.
ATTENTION: Potential Damage to Property. Failure to check the items listed below
may result in property damage.
ꢀ Clear the intended location of any damaged cables or pipes that might cause injury when
you are installing the device.
ꢀ Check that the installation meets the local and state regulatory
requirements, including building, electrical, and safety codes,
and UL and ADA accessibility requirements.
During installation, ensure that there is sufficient space behind the
device for the bend radius of the pigtail. The recommended
minimum bend radius is 0.80 inches (see image at right).
O
I
D
U
A
I
M
D
H
U
E
A
0
1
2
0.80"
C
P
W
(20.3 mm)
|