TM
3
HELIOS X
MODEL 2000000437
Before you begin
Parts and Components
Description
Read all instructions before set up.
• Select a level campsite clear of rocks, branches, and other hard
or sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees.
• For best results in windy conditions, position end of tent into
the wind.
• Enlist the help of at least one other person to assist you when
it is time to assemble the tent.
Part Number
5010000521
5010000523
5010000522
5010000525
Main Poles, Red (2)
Cross Poles, Silver (2)
Vestibule Poles, Gold (2)
Rainfly, Orange
To Set Up Tent
Fig. 1
Red Trim on Sleeve
1. Unfold tent and spread out on a
clean, level surface with the doors
facing the desired direction. (Fig. 1)
2. Stretch corners of tent until floor is
taut then hammer stakes through
loops on web straps to secure.
(Fig. 1A )
1B
Cutout in Red Sleeve
Silver
Cross Pole
Red, Shock-corded
Main Poles
Door
Door
3. Assemble two red main poles and
two silver cross poles by interlocking
the shock-corded poles.
4. Insert red main poles through
sleeves with red trim in top of tent
forming an “X” as shown. (Fig. 1)
5. Insert silver cross poles through
sleeves with silver trim in top of tent.
NOTE: Make sure the silver
Silver Trim on Sleeve
Silver, Shock-corded
Cross Poles
1A
poles pass through the cutouts in the
red trimmed sleeves and under the
red main poles. (Fig. 1 & 1B)
6. Insert one end of red main pole
into first grommet in web straps
at front corner of tent.
(Fig. 2 & 2A)
7. Go to opposite end of red main
pole and gradually apply pressure
to the pole forming an arch.
Insert the end of pole into first
grommet at the back corner of
tent. (Fig. 2 & 2A)
2B
Door
8. Repeat for second red main pole.
9. Insert one end of silver cross
pole into grommet in web strap
at side of tent. (Fig. 2 & 2B)
10. Go to opposite end of silver
cross pole and gradually apply
Stake through
loop
pressure to the pole forming an
arch. Insert the end of pole into
the grommet at other side of
tent. (Fig. 2)
2C
Stake through
loop
Red Main
Pole in first
grommet
Fig. 2
11. Repeat for second silver cross
pole forming an “X”. (Fig.2)
2A
12. Attach frame clips along edges of tent to red and silver poles. (Fig. 2 & 2B)
13. Clip plastic hooks, located on both sides of tent, to secure silver cross poles together as shown. (Fig. 2 & 2C)
14. Stretch sides of tent until floor is taut then hammer stakes through loops on web straps to secure.
(continued on other side)
|